A-46116-R lock cylinder and key assembly has been obsoleted. If calls are received for this part after present stocks are exhausted, supply A-46123-E lock cylinder and A-11586-C key. The key can be cut on your key cutting machine and the tumblers in the lock cylinder then fitted to the key.
A change has been made in the location of the screw which fastens the remote control connecting link to the door lock unit. This change has been made in all door locks used on the following type bodies: 160A, Band C. Sedans 190A Victoria 79B “A” Panel Delivery 225A “A” Panel Delivery Drop Floor 85B …
To lessen any possibility of the rear doors working loose when driving over exceptionally rough roads, a new rear door latch and rod assembly have been released for production and service on models 85-B “AA” panel delivery, 79-B “A” panel delivery and 225-A “A” panel delivery with drop floor. The following door latch and rod …
Please refer to December Service Bulletin, Page 516, showing interchangeable lock cylinders whereby the same key may be made to fit all the locks on the car. In a few instances traveling salesmen, driving coupes, have complained that when they store their cars in garages where it is necessary to leave the ignition key that …
Referring to lock cylinder removal article, on page 516, in December Service Bulletin, be sure the lock is in the unlocked position before attempting to remove the cylinder. Then after placing tool 52-2794 over the key, turn the key about 1⁄8 turn to the left and the lock cylinder will snap out of the lock.
A change has been made in the location of the door lock striker plate in coupes, roadsters and cabriolets . equipped with rumble seats. This change made it necessary, of course, to alter the position of the deck door lock to correspond with the new location of the striker plate. It will accordingly be necessary, …
The new inside and outside door handles which are now furnished as standard equipment on open cars can be easily installed on Phaetons and Roadsters not so equipped, by proceeding as follows: Remove old lock. Place new lock in place, fastening with two screws to locate. Drill through square hole in lock dog, using a …
Figure 578 shows the new deck door support now standard in roadster and all coupes without rumble seat. The new support can be easily installed on cars equipped with the old-design support by proceeding as follows: Drill a 9/32” hole in deck drain trough 3-3/32” from center line of rivet “B.” (See fig 579.) Next …
When installing a window regulator handle, make sure that the handle is installed so that it is on the downward travel when window is closed tight. (See Fig 503) this will prevent any possibility of the weight of the handle slightly lowering the window when traveling over rough roads.
©2023 Model A Garage, Inc.
Designed, Powered, and Managed By Shenandoah Business Solutions ⚡
